Instructions for Filter Membrane
The conventional membrane filter device comprises vacuum manifolds filtration system, joint flask, and the vacuum source. Conspicuously, the essential part is the filtration system, which consists of three glass filter holders with respective values and two handles placed on both sides.
Specific Operations
1. Loosen the bottom nut and lift the fixed mount, then place a rubber ring under the porous plate and a membrane gasket on that plate. Next, put the microporous filter membrane on it and place the filter gasket, then install the glass tube and a sealed sheet rubber on the top of the tube. Mount the fixator, tighten the bottom nut, and the cover the top lid.
2. Remove the top sheet rubber for the unsealed environment.
3. Connect the bottom drainage pipe with a rubber pipe, and wrap the orifice with gauze.
4. Warp up the whole filter and its base together then sterilize them at 121℃.
Precautions
1. Slightly loosen the filter cover or pierce a syringe filter before steam sterilization and connect to the air filter for ventilation.
2. Immerse the membrane into sterile water for 4- 6 hours before sterilization, then pour the water and operate the same way as above overnight.
Contact : Bruce Lu, +86 29 89284429
Good deal: buying from seller
We invite you to read our terms of use. You can also visit our FAQ section and see our information section on the risks associated with counterfeiting.
This page is about importers and exporters of Instructions for Filter Membrane Search in a category : Everything else / Bulk Search in a category : instructions, filter, membrane |
Thursday, October 29, 2015
AKSA PEYZAJ and PARK TASARIM, which have been designing and manufacturing city furniture and playground equipment since they were established in 1996 ,have joined forces for children all over the world and have become AKSAPARK KENT MOBILYALARI INC. AKSAPARK, which offers high quality...
Aksapark Kent Mobilyaları
- aksapark
- 06380 - Sincan
- +903122671100
Friday, May 16, 2014
Quantity : 50000pcs - Price : $1-25/pc
Prototype Description SLA and SLS Why Use Stereolithography? Stereolithography is very similar to the SLS(Selective Laser Sintering) prototyping process.It's best to use SLA,when surface finish and overall appearance straight from the machine is the most important factor in the prototype...
Xiamen Karo Co.,Ltd
- karoplastic
- 361002 - Xiamen
- 0086 592 5135406
Friday, May 16, 2014
Quantity : 500000pcs - Price : $1-25/pc
Prototype Description SLA and SLS Why Use Stereolithography? Stereolithography is very similar to the SLS(Selective Laser Sintering) prototyping process.It's best to use SLA,when surface finish and overall appearance straight from the machine is the most important factor in the prototype...
Xiamen Karo Co.,Ltd
- karoplastic
- 361002 - Xiamen
- 0086 592 5135406