SOLVENTS - 1859 ads

Thursday, July 11, 2019

The Mimaki JV33/JV5 printhead is either used in 4-colours or 6-colours and has a minimum, variable droplet size of 1.5 pico litre (max. droplet size is 21 pico litre). The typical firing frequency for this print head is 8 kHz. It is a new generation printhead that allows fast speed...

Thursday, July 11, 2019

The JV34-260 Printhead ID Set can be used in 4-colour or 8-colour printers and has a minimum, variable droplet size of 1.5 pico litre (max. droplet size is 21 pico litre). The typical firing frequency for the JV34-260 Printhead ID Set is 8 kHz. The JV34-260 Printhead ID Set solvent...

Thursday, July 11, 2019

1. Aspiration and drainage Vertical aspiration; the tip of the tip is immersed in the liquid surface below 3mm. The tip of the tip is pre-flushed in the liquid before the aspiration; slow suction and slow release; if the amount is small when the liquid is discharged, the tip of the...

Thursday, July 11, 2019

Filter cartridges are purification equipment, with long service life, strong pollution capacity and low pressure and other characteristics, which are suitable for pharmaceutical, food, petroleum, electronic, chemical, metallurgical and textile industries. Features of filter cartridges 1...

Thursday, July 11, 2019

First, the purpose of the request The colorectal flora in water was determined by the membrane method. Second, the basic principles The filter membrane method uses a filter to filter the water sample, and the bacteria are trapped on the filter membrane, and then the filter membrane...

Wednesday, July 10, 2019

According to the research from the United States Department of Agriculture, the QuEChERS meth od which extracts pesticide from foods is fast, convenient, cheap, effective and secure. When it compares to the traditional SPE method, QuEChERS not only uses less solvent but also adopts...

Wednesday, July 10, 2019

Cellulose extraction thimbles are widely used in Soxhlet extractors. Soxhlet extraction is a widely used technology to analyze lipids or pesticides in food and soil materials and others. Soxhlet extraction is the continuous extraction of the required components in the solid mixture...

Wednesday, July 10, 2019

A bottle-top dispenser is a device installed at the mouth of a solvent bottle to take a large amount of solution and has been constantly updated and improved to meet the growing operational requirements of the laboratory for more than ten years. There are two kinds of bottle-top dispensers...

Tuesday, July 09, 2019

The cleaning of sample vial is very important. Usually, according to the principle of glass instrument washing and the degree of pollution to choose cleaning methods, there is no fixed mode. The specific methods are as follows: Method one: 1. Dry the sample in the sample vial. 2...

Tuesday, July 09, 2019

Melt-blown filter cartridges are shaped filter cartridges, which made of non-toxic and odorless polypropylene particles after heating, melting, spinning, traction. Melt-blown filter cartridges are not only used in water purification, but also have excellent chemical compatibility...

Tuesday, July 09, 2019

First, the purpose of the request The colorectal flora in water was determined by the membrane method. Second, the basic principles The filter membrane method uses a filter to filter the water sample, and the bacteria are trapped on the filter membrane, and then the filter membrane...

Tuesday, July 09, 2019

The reversed-phase HPLC columns may be repeatedly injected into a sample containing a strongly retained material, and in particular, the sorbent components such as large molecular weight or hydrophobic biological flow proteins and strong alkaline substances may be adsorbed on the silica medium...

Monday, July 08, 2019

SPE Technique Introduction SPE(Solid-phase Extraction), is an increasingly popularized technology of sample pretreatment, which is established on the basis of traditional LLE(Liquid-liquid Extraction). Combined with the substance interaction mechanism that like dissolves like, and...

Monday, July 08, 2019

As a simple and fast absorption chromatography technique for the routine purification of organic compounds, flash chromatography is developed for the daily purification of reaction products in the lab, which is low costs and achieves separations of samples (0.01-10.0 g weight) in short time...

Monday, July 08, 2019

HPLC is the separation of sample components between the column packing and the mobile phase for mass exchange. Therefore, the mobile phase is required to have the following characteristics: a. the flow relative to the sample has a certain solubility, to ensure that the sample components...

Friday, July 05, 2019

Hawach scientific is a professional vacuum pump manufacturers, product quality through a number of international standards, and exported to more than 120 countries all over the world. More detail information and quotation about the products contact with info@hawach.com. Diaphragm...

Friday, July 05, 2019

Generally speaking, bottle-top dispenser which is a scientific device could improve the wide application, safety performance, speed and reliability. In addition, it could save your time and work, even protect you and your samples. To be more specific, the advantages of the bottle-top...

Thursday, July 04, 2019

C8 HPLC columns are used to isolate many organic compounds, which are one of the reversed phase silica gel columns. The maintenance of C8 HPLC columns requires organic solvents. Chromatographic grade methanol is recommended and different brands of chromatographic columns should be...

Thursday, July 04, 2019

The filler of polymeric HLB SPE cartridges produced by a special copolymerization technology contains a certain proportion of the hydrophilic group and the hydrophobic group. Hydrophobic divinyl benzene structures retain nonpolar compounds and hydrophilic n-vinyl pyrrolidone structures...

Thursday, July 04, 2019

Flash column chromatography method is to separate the constituents from the mixture and thus purify it. In a word, flash column chromatography makes the samples go through the column which is filled with gel to achieve separation. In the beginning, the founder of flash column chromatography, Mr...

Thursday, July 04, 2019

Brief introduction of the capsule filter The bag filter is also called abandoned filter. Its shell is made of high-temperature polypropylene material. The inner filter core is made of folded filter core welded together by hot fusion. It is suitable for filtering small doses of liquid...

Thursday, July 04, 2019

(1) When loading and unloading or replacing the HPLC columns, the action should be light and the joint should be tightened properly. Strong mechanical vibration must be prevented to avoid voids in the bed. (2) If the instrument is used for routine analysis, the sample type is limited...

Thursday, July 04, 2019

Activation, also known as solvation, add a suitable solvent to expand the functional groups on the adsorbent and remove possible interferences on the adsorbent. Equilibrium, remove the activated solvent to create a suitable solvent environment for sampling. Usually, use the same solvent...

Wednesday, July 03, 2019

Chromatographic analysis technology has been widely used nowadays. It is quite important to clean the chromatographic sample vials carefully. When the number of samples is enormous, a large number of chromatographic sample vials need to be cleaned during the experiments. If the sample...

Wednesday, July 03, 2019

Flash column chromatography is an efficient way to separate complex mixtures of compounds in the lab. we use compressed air to push the solvent through the column when we are running flash columns. It can help provide better separation and cut down the running time as while. Flash...

Wednesday, July 03, 2019

Capsule filters are available in various sizes and can be autoclaved, which have four interfaces, two of which inlet and outlet of the filtered liquid are in the middle. One of the two sides is a vent, the other is a drain. Features of capsule filters 1. 1/4 male thread interface...

Tuesday, July 02, 2019

Pip ettes are often used in laboratories, schools, research institutes, hospitals, etc. Among the many pipette types, multi-channel pipettes are pipettes with multiple tips, so some users are in use. It is found that the pipette tip suction amount is inconsistent. What causes the...

Tuesday, July 02, 2019

The average sample addition recovery rate of QuEChERS method is higher than 85%, with fewer impurities interfering with the detection of the target substance, a small amount of solvent, simple and fast operation, which will be the preferred pretreatment method for routine detection...

Tuesday, July 02, 2019

Fitting most commercially available Soxhlet extractors, we offer a variety of selection of high-quality extraction. To achieve an efficient and reliable analysis in the lab, the extraction thimbles are used to extract certain components out of the sample of solid material. The thimbles...

Tuesday, July 02, 2019

In this article, we want to clarify the syringe filter. Each of the different syringe filters is applied to the specific product Which the various syringe filter is worth seeing more and what are the right steps and methods to have a try. Classification by membrane The filtration...