SOLVENTS - 1817 ads

Monday, July 08, 2019

SPE Technique Introduction SPE(Solid-phase Extraction), is an increasingly popularized technology of sample pretreatment, which is established on the basis of traditional LLE(Liquid-liquid Extraction). Combined with the substance interaction mechanism that like dissolves like, and...

Monday, July 08, 2019

As a simple and fast absorption chromatography technique for the routine purification of organic compounds, flash chromatography is developed for the daily purification of reaction products in the lab, which is low costs and achieves separations of samples (0.01-10.0 g weight) in short time...

Monday, July 08, 2019

HPLC is the separation of sample components between the column packing and the mobile phase for mass exchange. Therefore, the mobile phase is required to have the following characteristics: a. the flow relative to the sample has a certain solubility, to ensure that the sample components...

Friday, July 05, 2019

Hawach scientific is a professional vacuum pump manufacturers, product quality through a number of international standards, and exported to more than 120 countries all over the world. More detail information and quotation about the products contact with info@hawach.com. Diaphragm...

Friday, July 05, 2019

Generally speaking, bottle-top dispenser which is a scientific device could improve the wide application, safety performance, speed and reliability. In addition, it could save your time and work, even protect you and your samples. To be more specific, the advantages of the bottle-top...

Thursday, July 04, 2019

C8 HPLC columns are used to isolate many organic compounds, which are one of the reversed phase silica gel columns. The maintenance of C8 HPLC columns requires organic solvents. Chromatographic grade methanol is recommended and different brands of chromatographic columns should be...

Thursday, July 04, 2019

The filler of polymeric HLB SPE cartridges produced by a special copolymerization technology contains a certain proportion of the hydrophilic group and the hydrophobic group. Hydrophobic divinyl benzene structures retain nonpolar compounds and hydrophilic n-vinyl pyrrolidone structures...

Thursday, July 04, 2019

Flash column chromatography method is to separate the constituents from the mixture and thus purify it. In a word, flash column chromatography makes the samples go through the column which is filled with gel to achieve separation. In the beginning, the founder of flash column chromatography, Mr...

Thursday, July 04, 2019

Brief introduction of the capsule filter The bag filter is also called abandoned filter. Its shell is made of high-temperature polypropylene material. The inner filter core is made of folded filter core welded together by hot fusion. It is suitable for filtering small doses of liquid...

Thursday, July 04, 2019

(1) When loading and unloading or replacing the HPLC columns, the action should be light and the joint should be tightened properly. Strong mechanical vibration must be prevented to avoid voids in the bed. (2) If the instrument is used for routine analysis, the sample type is limited...

Thursday, July 04, 2019

Activation, also known as solvation, add a suitable solvent to expand the functional groups on the adsorbent and remove possible interferences on the adsorbent. Equilibrium, remove the activated solvent to create a suitable solvent environment for sampling. Usually, use the same solvent...

Wednesday, July 03, 2019

Chromatographic analysis technology has been widely used nowadays. It is quite important to clean the chromatographic sample vials carefully. When the number of samples is enormous, a large number of chromatographic sample vials need to be cleaned during the experiments. If the sample...

Wednesday, July 03, 2019

Flash column chromatography is an efficient way to separate complex mixtures of compounds in the lab. we use compressed air to push the solvent through the column when we are running flash columns. It can help provide better separation and cut down the running time as while. Flash...

Wednesday, July 03, 2019

Capsule filters are available in various sizes and can be autoclaved, which have four interfaces, two of which inlet and outlet of the filtered liquid are in the middle. One of the two sides is a vent, the other is a drain. Features of capsule filters 1. 1/4 male thread interface...

Tuesday, July 02, 2019

Pip ettes are often used in laboratories, schools, research institutes, hospitals, etc. Among the many pipette types, multi-channel pipettes are pipettes with multiple tips, so some users are in use. It is found that the pipette tip suction amount is inconsistent. What causes the...

Tuesday, July 02, 2019

The average sample addition recovery rate of QuEChERS method is higher than 85%, with fewer impurities interfering with the detection of the target substance, a small amount of solvent, simple and fast operation, which will be the preferred pretreatment method for routine detection...

Tuesday, July 02, 2019

Fitting most commercially available Soxhlet extractors, we offer a variety of selection of high-quality extraction. To achieve an efficient and reliable analysis in the lab, the extraction thimbles are used to extract certain components out of the sample of solid material. The thimbles...

Tuesday, July 02, 2019

In this article, we want to clarify the syringe filter. Each of the different syringe filters is applied to the specific product Which the various syringe filter is worth seeing more and what are the right steps and methods to have a try. Classification by membrane The filtration...

Tuesday, July 02, 2019

The key to regenerating contaminated HPLC columns is to know the nature of the contaminants and to find the right solvent to remove. If contamination is caused by the accumulation of strongly retained materials during repeated injections, simple steps to remove these contaminants...

Monday, July 01, 2019

- RTV-1 Silicone Rubber - RTV-1 silicone is a condensed non conductive silicone rubber that is gradually cured from outside to inside by contacting with moisture in the air. rtv grease-1 silicone rubber are used in bonding, sealing, encapsulating photovoltaic module components including...

Monday, July 01, 2019

- Low VOC Silicone Modified Polyurethane Conformal Coating - L325 - - FEATURES OF GOLOHO-L325 - ·Convenient to use: organic silicon modified polyurethane type, good waterproof, easy to repair. ·Neutral, no corrosion for many metals, anti-yellowing. Outstanding bond strength for...

Monday, July 01, 2019

Usually, there are two essential properties that end users are the most—extractability of the impurities and advantages of microporous polymer membranes. Extractability of The Impurities Scientific laboratories mostly apply the membrane product to filter samples, mobile phase, and...

Monday, July 01, 2019

After selecting the type of SPE cartridges, we have to determine the specifications of the SPE cartridge. The principle of selecting the SPE cartridge specification is to first ensure that the SPE cartridge packing has sufficient capacity to retain the target compound 100% on the column...

Saturday, June 29, 2019

Quantity : 1 - Price : US $7.00 - 8.00/ Pie

Application: HD PE is used where sliding abrasion occurs or where metal parts meet, causing friction or abrasion wear. It is good for chute and hopper liners, convey or components, wear pads, machine guides, impact surface and guide rails. Performance: Polyethylene board odorless...

Friday, June 21, 2019

1. Capacity setting For the adjustable pipette, it is usually operated in the range of 10% to 100%. The optimal pipetting capacity is in the range of 35% to 100%. At this time, it is less affected by the operation technique and can better protect the pipetting. Accuracy and precision...

Friday, June 21, 2019

We can always hear such a conversation between those researchers. “Hey, buddy, what is your purity degree of the end products today?” “Damn it. Such a low degree that I cannot even use for the next step. Any better methods for clarifying raw materials?” Then there comes Hawach syringe filter...

Friday, June 21, 2019

The material of the nylon membrane filter is aliphatic nylon. It has good hydrophilicity, the appropriate concentration of acid and alkali resistant, and applies not only acid and alkaline aqueous solution, but also suitable for organic solvent, such as s, hydrocarbon, ethers, esters...

Friday, June 21, 2019

Normally SPE cartridge has two basic adsorption modes: target compound adsorption mode, impurity adsorption mode; 5 operation modes: gravity operation, manual positive pressure, centrifuge, negative pressure and positive pressure mode. Now let's review the whole process step by step...

Thursday, June 20, 2019

Basic Knowledge of Vacuum Filtration Based on the principle that under the same pressure (vacuum degree), the vaporization temperature of the water is lower than that of oil, scientists make practical equipment which is called vacuum filter. In fact, vacuum filtration is the most...

Thursday, June 20, 2019

Suitable for Soxhlet-type and other similar devices, the extraction thimbles are used to adapt a sample of solid material to extract certain components out, with the addition of sufficient and appropriate solvent. Cellulose extraction thimbles which are made of high-quality alpha...