SOLVENTS - 1808 ads

Thursday, July 04, 2019

(1) When loading and unloading or replacing the HPLC columns, the action should be light and the joint should be tightened properly. Strong mechanical vibration must be prevented to avoid voids in the bed. (2) If the instrument is used for routine analysis, the sample type is limited...

Thursday, July 04, 2019

Activation, also known as solvation, add a suitable solvent to expand the functional groups on the adsorbent and remove possible interferences on the adsorbent. Equilibrium, remove the activated solvent to create a suitable solvent environment for sampling. Usually, use the same solvent...

Wednesday, July 03, 2019

Chromatographic analysis technology has been widely used nowadays. It is quite important to clean the chromatographic sample vials carefully. When the number of samples is enormous, a large number of chromatographic sample vials need to be cleaned during the experiments. If the sample...

Wednesday, July 03, 2019

Flash column chromatography is an efficient way to separate complex mixtures of compounds in the lab. we use compressed air to push the solvent through the column when we are running flash columns. It can help provide better separation and cut down the running time as while. Flash...

Wednesday, July 03, 2019

Capsule filters are available in various sizes and can be autoclaved, which have four interfaces, two of which inlet and outlet of the filtered liquid are in the middle. One of the two sides is a vent, the other is a drain. Features of capsule filters 1. 1/4 male thread interface...

Tuesday, July 02, 2019

Pip ettes are often used in laboratories, schools, research institutes, hospitals, etc. Among the many pipette types, multi-channel pipettes are pipettes with multiple tips, so some users are in use. It is found that the pipette tip suction amount is inconsistent. What causes the...

Tuesday, July 02, 2019

The average sample addition recovery rate of QuEChERS method is higher than 85%, with fewer impurities interfering with the detection of the target substance, a small amount of solvent, simple and fast operation, which will be the preferred pretreatment method for routine detection...

Tuesday, July 02, 2019

Fitting most commercially available Soxhlet extractors, we offer a variety of selection of high-quality extraction. To achieve an efficient and reliable analysis in the lab, the extraction thimbles are used to extract certain components out of the sample of solid material. The thimbles...

Tuesday, July 02, 2019

In this article, we want to clarify the syringe filter. Each of the different syringe filters is applied to the specific product Which the various syringe filter is worth seeing more and what are the right steps and methods to have a try. Classification by membrane The filtration...

Tuesday, July 02, 2019

The key to regenerating contaminated HPLC columns is to know the nature of the contaminants and to find the right solvent to remove. If contamination is caused by the accumulation of strongly retained materials during repeated injections, simple steps to remove these contaminants...

Monday, July 01, 2019

- RTV-1 Silicone Rubber - RTV-1 silicone is a condensed non conductive silicone rubber that is gradually cured from outside to inside by contacting with moisture in the air. rtv grease-1 silicone rubber are used in bonding, sealing, encapsulating photovoltaic module components including...

Monday, July 01, 2019

- Low VOC Silicone Modified Polyurethane Conformal Coating - L325 - - FEATURES OF GOLOHO-L325 - ·Convenient to use: organic silicon modified polyurethane type, good waterproof, easy to repair. ·Neutral, no corrosion for many metals, anti-yellowing. Outstanding bond strength for...

Monday, July 01, 2019

Usually, there are two essential properties that end users are the most—extractability of the impurities and advantages of microporous polymer membranes. Extractability of The Impurities Scientific laboratories mostly apply the membrane product to filter samples, mobile phase, and...

Monday, July 01, 2019

After selecting the type of SPE cartridges, we have to determine the specifications of the SPE cartridge. The principle of selecting the SPE cartridge specification is to first ensure that the SPE cartridge packing has sufficient capacity to retain the target compound 100% on the column...

Saturday, June 29, 2019

Quantity : 1 - Price : US $7.00 - 8.00/ Pie

Application: HD PE is used where sliding abrasion occurs or where metal parts meet, causing friction or abrasion wear. It is good for chute and hopper liners, convey or components, wear pads, machine guides, impact surface and guide rails. Performance: Polyethylene board odorless...

Friday, June 21, 2019

1. Capacity setting For the adjustable pipette, it is usually operated in the range of 10% to 100%. The optimal pipetting capacity is in the range of 35% to 100%. At this time, it is less affected by the operation technique and can better protect the pipetting. Accuracy and precision...

Friday, June 21, 2019

We can always hear such a conversation between those researchers. “Hey, buddy, what is your purity degree of the end products today?” “Damn it. Such a low degree that I cannot even use for the next step. Any better methods for clarifying raw materials?” Then there comes Hawach syringe filter...

Friday, June 21, 2019

The material of the nylon membrane filter is aliphatic nylon. It has good hydrophilicity, the appropriate concentration of acid and alkali resistant, and applies not only acid and alkaline aqueous solution, but also suitable for organic solvent, such as s, hydrocarbon, ethers, esters...

Friday, June 21, 2019

Normally SPE cartridge has two basic adsorption modes: target compound adsorption mode, impurity adsorption mode; 5 operation modes: gravity operation, manual positive pressure, centrifuge, negative pressure and positive pressure mode. Now let's review the whole process step by step...

Thursday, June 20, 2019

Basic Knowledge of Vacuum Filtration Based on the principle that under the same pressure (vacuum degree), the vaporization temperature of the water is lower than that of oil, scientists make practical equipment which is called vacuum filter. In fact, vacuum filtration is the most...

Thursday, June 20, 2019

Suitable for Soxhlet-type and other similar devices, the extraction thimbles are used to adapt a sample of solid material to extract certain components out, with the addition of sufficient and appropriate solvent. Cellulose extraction thimbles which are made of high-quality alpha...

Thursday, June 20, 2019

Firstly, let's divide those bottle-top dispensers into 3 groups according to their materials A. Highly corrosion resistant materials such as PTFE, PFA, boron silicate, platinum, etc. Application: Resistant to high-temperature sterilization (121℃), withstand most of the acid, alkali...

Thursday, June 20, 2019

PTFE stands for Poly Tetra Fluoroethylene. People generally call it non-sticking lining or easy-cleaning material. The material of PTFE has the characteristics of antiacid and antisolvent, which means it is hardly insoluble in all solvents. And PTFE is heat-resistant and with low...

Wednesday, June 19, 2019

Hawach Scientific Co., Ltd is main laboratory supplies and industrial filter manufacturing enterprises, from raw materials and production process to ensure the maximum quality monitoring, each batch of a strict quality testing and product warranty. At present, users are distributed...

Wednesday, June 19, 2019

Hawach scientific takes filtration technology as its core and manufactures high-quality filtration products. Our products after years of research and development, the use of advanced technology and first-class production equipment, to provide customers with all kinds of high-quality...

Wednesday, June 19, 2019

SPE cartridges, with a full name of Solid Phase extraction cartridges, is also called the SPE column( solid phase extraction column). The solid phase extraction column/cartridges is a pretreatment device for the sample being analyzed, which developed from the chromatographic column...

Tuesday, June 18, 2019

Hawach glass solvent filters is an important part of laboratory filtration, and many customers often encounter cleaning problems when using glass solvent filters. The conventional cleaning methods mainly include the following: 1. Soaking with an acidic solvent: The advantage of this...

Tuesday, June 18, 2019

A more efficient way to extract compounds from solid materials—Soxhlet extraction (also known as sand extraction). In the laboratory, Soxhlet extractor uses solvent reflux and siphon principle, so that the solid substance is continuously extracted by pure solvent, which saves solvent...

Sunday, June 16, 2019

Ceramic Nanofiltration membrane is relatively recent membrane filtration system, with the purpose of softening and removal of disinfection by-product precursors such as natural organic matter and synthetic organic matter. More ultrafiltration membrane system details here! CHARACTERISTICS...

Saturday, June 15, 2019

What is SPE Cartridge? The term SPE cartridges is short for Solid Phase Extraction cartridge. It is a kind of sample preprocessing equipment (extract, separate and concentrate) which is developed from the chromatographic column. SPE cartridge is mainly used for preprocessing of the...