PP Melt-Blown Filter Cartridge Feature
First, the continuous polypropylene long fibers produced by the melt-blown process are wound with polypropylene as raw material.
Second, high filtration accuracy, large flow rate, uniform structure, large contamination capacity, and long service life.
Third, good chemical compatibility, without any additives, the fiber is not easy to fall off.
Fourth, PP melt-blown filter cartridge with widely used and high dirt retention capacity.
In the deep layer of the filter cartridge, the effect of capturing particulate matter according to the density can be realized, and the effectiveness of the filter core can be given full play.
Higher soil retention means longer service life and lower replacement frequency and cost savings; The surface density of the filter element is low, but from the surface to the center of the filter element, the density increases gradually; There are no surface blind spots that will reduce the flow rate of the filter element and increase the replacement frequency.
High temperature bonded fiber; does not contain moisturizers, antistatic agents and binders; extensive chemical resistance; easy to handle after incineration; meets the requirements of FDA food and beverage industry; does not produce dissolution and release.
Contact : Bruce Lu, +86 29 89284429
Good deal: buying from seller
We invite you to read our terms of use. You can also visit our FAQ section and see our information section on the risks associated with counterfeiting.
This page is about importers and exporters of PP Melt-Blown Filter Cartridge Feature Search in a category : Everything else / Bulk Search in a category : filter, feature, blown, melt, cartridge |
Friday, May 16, 2014
Quantity : 5000000pcs - Price : $0.25-5/pc
Plastic Injection Parts Description Company Profile: We specilizes in developing and producing plastic injection parts and injection moulds for electrical appliances,home appliances,computers,telecommunication devices,pharmaceutical appliances, bathroom accessories and building...
Xiamen Karo Co.,Ltd
- karoplastic
- 361002 - Xiamen
- 0086 592 5135406
Thursday, June 16, 2016
Application Method 1. Glue is applied on textile or leather. 2. Patterned or fully coated glue is fixed by heat before foil transfer properly. 3. Stamping the foil ,heat: 130C-150C, pressure 4-6 bar, touch time 3-5 s. 4. Discard the carrier film after stamping process.Different...
UES Makine Tekstil Inşaat ve Gida San.Tic.Ltd.Şti
- 34510 - Istanbul
- +902125571040
Thursday, August 06, 2015
Quantity : 30 sets
The X. Y& Z axis utilizes AC servo motor. Multi-cavities machining, ORBIT-CUT machining & Helix machining. A.T.C. (Automatic Tool change) & C-axis machining available. The Circle Angle of Sparking is lower than 0.02mm. The best surface roughness (Ra) is better than 0...
Sane Kuei Machinery Co., Ltd
- Sane Kuei Machinery Co., Ltd
- 24158 - New Taipei City
- +886285112370