4500 Lumens 1920x1080 Ultra Short Throw Laser Projector DM907

4500 lumens, 1920*1080 native resolution, 0.25 ultra short throw laser projector

DM907 has 4500 ANSI lumens with 1920*1080 native resolution, and it also has the built-in edge blending function. The function of 17*17 geometric correction can change the image into any different shapes. The 0.25 ultra short throw can reduce the distance between the projector and the screen. DM907 has a touch control function, which makes it more suitable for the interactive classroom.

ORDER NOW CONTACT US

Functions of Laser Projectors

Parameter

Adopts Texas Instruments DLP technology and 1080p 0.65” chips

Adopts SSI laser light source technology and the service life is over 20000 hours

The brightness is 4500 lumens and the contrast ratio is 10000: 1 APM

DM907 has the built-in I-chip, not only support vertical and horizontal keystone correction, but also support 2*2, 3*3, 5*5, 9*9, 17*17 geometric correction. It can support up to 289 adjustment points.

Ultra short throw lens and reflective design

Built-in infrared camera, no need to add the electronic whiteboard

Built-in edge blending function, and built-in the splicing and edge blending mode

Support orthographic projection, back projection, side projection, top projection and 2*360° projection.

Support active 3D stereo projection

Support PIP, PBP projection mode

Equipped the high definition interface HDMI*2 and MHL function

Multiple signal input ports with 2 channels different signals sync input

RS232 （D-sub 9-pin*1）port, and support various long-range control and centralized management

The minimum stand mode power is less than 0.5 watt

Support wall color compensation function

It has the detection signal auto power on function and the users can control the DM907 when controlling the front-end signal source

Support 7*24 hours projection

Ultra short throw lens

DM907 adopts the high definition ultra short throw lens with the reflective design. It can achieve ultra-short focus projection distance while ensuring that the projected image is clear and uniform without deformation. This design can fully save the installation distance.

The throw ratio of the DM907 is only 0.25: 1, so a 100-inch image only need 55cm projection distance.

Environmental friendly laser light source

This projector adopts the new laser light source, which has the advantages of the wider color gamut, exquisite color quality, over 20000hours service life, smaller energy consumption and so on.

High brightness for more usage scenarios

The 4500lumens brightness can meet the needs of many occasions all day.

It can provide high brightness images in the conference rooms, classrooms, indoor advertisements for 24 hours.

Geometric correction

DM907 adopts the 2*2, 3*3, 5*5, 9*9, 17*17 geometric correction function. The single projector can project to the irregular screen( for example arc screen), and the image will be faultlessly projected into the screen through adjusting the grid points.

DM907 can achieve the creative display no need to add the other equipment even the irregular wall. Users can also set several different projected shapes to be stored inside the device.

Support single-point and multi-point touch control

Single DM907 or 2 pieces DM907 can achieve the interactive touch control for ten points at the same time. The stylus makes sure the touch control is accurate, no delay and no- break.

This design can replace the interactive way of electronic whiteboard and projection, which can supply more convenient solutions for the interactive classrooms.

Built-in edge blending function

DM907 laser video display short throw projector 4500 lumens has a series of edge blending modules, which can realize the high definition and ultra large screen by the edge blending function of more than one DM907.

The multiple edge blending function can be achieved by the card display. It is a kind of image cutting processor. DM907 has the "edge blending" mode, which can automatically process the brightness of the fusion zone and the non-fusion zone.

High definition

With the 1080p native resolution, the image quality of the DM907 can achieve to the full HD and the image is more clear.

The 16: 9 widescreen proportion is same as the standard films and television proportion.

Adopts the dual color wheel technology

DM907 adopts the four-part forms of Filter Wheel and Phos-phorWheel. Red light has a higher proportion, so the images are more realistic. The color's amount is reached to 10.7billion.

Full 3D format

With the TI signal processing chip, this DM907 can connect Blu-ray drive, tv box, games and 3D device. It is no need to prepare other signal converters can realize 3D projection, which made teaching demonstration, business speech, entertainment display more real and vivid.

Rich and practical interfaces

This projector equipped with HDBaseT interface supporting 20Gbps transmission rate, the transmission distance is up to 100 meters.

VGA*1, Audio Jack*1, HDMI*2, RJ45 HDBaseT x 1, mircrophone jack*1, RS-232C x 1 , Mini USB x 1 VGA x 1 , Audio Jack x 1 RJ45 X 1 USB-A X 1 (5V@2A)

RS232 interface and keypad support various remote control and centralized management (Crestron/ Ectron/PJ Link/ AMX/ Telnet). Users can use different control devices for remote control and centralized management according to the requirements of the application environment.

DHN-Professional 3D HD Laser Projector Supplier

Laser projectors (laser action projector) use laser beams to transmit images. The optical components of the laser beam projector are mainly composed of RGB light valve, X prism, projection lens and drive light valve.

The laser beam passes through the corresponding optical elements and the beam expansion of the processing chip in the machine, and then transmits to the X prism to integrate the three laser beams. Then the integrated laser is transmitted to the projection screen by the projection objective lens, and the entire display process of the digital laser projector is completed.