10G SFP+ DAC

SFP+ Direct Attach Cables are compliant with the SFF-8431, SFF-8432 and SFF-8472 specifications. Various choices of wire gauge are available from 30 to 24 AWG with various choices of cable length (up to 7m).

Over the past more than two decades, as a professional fiber supplier in Chian, T&S Communications has combined its proud expertise in ceramics materials, fiber optical connectivity, and transmission with powerful manufacturing and engineering capabilities to develop inspiring innovations and marketable optical communications products.

Features of 10G Direct Attach Cable

Compliant with SFF-8431, 8432 and 8472.

Up to 10.3125Gbps data rate per channel

Up to 7m transmission

Single 3.3V power supply

Temperature Range: 0~ 70 °C

RoHS compliant

Applications of 10G SFP+ Direct Attach Cable

Low EMI radiation Switches, servers and routers

Data Center networks

Storage area networks

High performance computing

Telecommunication and wireless infrastructure

Medical diagnostics and networking

Test and measurement equipment

Specifications of 10G SFP+ Direct Attach Cable

General Product Characteristics

High Speed Characteristics

Regulatory Compliance

Recommended Operation Condition of 10G SFP+ Direct Attach Cable

Notes:

Stress or conditions exceed the above range may cause permanent damage to the device.

This is a stress rating only and functional operation of the device at these or any other conditions above those listed in the operational sections of this specification is not applied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

Pin definition of 10G SFP+ Direct Attach Cable

Notes:

1. Module circuit ground is isolated from module chassis ground within the module.

2..should be pulled up with 4.7k – 10k ohms on host board to a voltage between 3.15Vand 3.6V.

3.Tx_Disable is an input contact with a 4.7 kΩ to 10 kΩ pullup to VccT inside the module.

4.Mod_ABS is connected to VeeT or VeeR in the SFP+ module. The host may pull this contact up to Vcc_Host with a resistor in the range 4.7 kΩ to10 kΩ.Mod_ABS is asserted “High” when the SFP+ module is physically absent from a host slot.

5. RS0 and RS1 are module inputs and are pulled low to VeeT with > 30 kΩ resistors in the module.

Mechanical Dimensions of 10G SFP+ Direct Attach Cable

The connector is compatible with the SFF-8432 specification.